New to the DSM world

[Budwsr]

Hey all new to the DSM world, living in N colo Loveland to be exact.
bought a 91 talon of a guy for 300 bucks, blown engine put a few valcves threw the pistons. make a long story short bought a JDM engine changed timing belt, ended up droping and pullig the engine 2times tranny twice as I had to changge a flywheel ( buddy gaurenteed me that it would fit, awd 10" diam FWD 11" diam) got it all together started rough but got better. well now I'm at the point where it won't even run. checked the volts on all injectors #3 was low voltage, swapped ecus to see if that would help nothing. when I drove it around theblock ( didn't dare go farther than that) it stalled numerous times and I could hear a ticking and popping noise coming from the ECU ( hence the swap nothing)
I have spark going to all plugs and I have plenty of fuel coming off the fuel filter any ideas??
anything would help allot. not sure this was such a hot pruchase :rolleyes:

[Hal]

Since you r&r'd the motor virtually every sensor is going to be suspect.

Unplugged, broken wires (esp. injector connectors), grounds, alternator not charging the battery, etc.

Since this is your first post, I'll refer you to the rules.

Proper grammer, spelling, and punctuation does count here.

Hal