DSM Work - Tonight Feb 8

[mac214]

I am going to be working on the DSM tonight. If anyone wants to stop by and hang out, feel free to PM me and I will give you directions. I will probably start on the car around 6.

[biglady112]

Good luck Mike. Hopefully all goes well the next few days. Then I hope we can tune the bitch next week. Its been a while coming.

I forgot to ask yesterday, what are the important mods. You know, motor setup and turbo/fuel setup. What are you expecting and what do you ballpark her as doing.

Steven

[mac214]

I am only planning on running about 20-22 psi on pump gas with around a 10.5 AFR. I really want to keep my street tune safe and get all the bugs worked out.

I will start really tuning the car when the season gets close and work up a couple of maps on different boost with race gas.

I am also going to dyno tune it next month and am hoping for around 400 hp.

Hopefully, no other issues will be found when I finally get to start the car ;)

[mac214]

Good luck Mike. Hopefully all goes well the next few days. Then I hope we can tune the bitch next week. Its been a while coming.

I forgot to ask yesterday, what are the important mods. You know, motor setup and turbo/fuel setup. What are you expecting and what do you ballpark her as doing.

Steven

Motor is a fresh rebuild but was done using stock components. The mods are Race FMIC with short route piping, GM 3" MAF, DSMLink, 680cc injectors, and PTE SCM 60-1.

[biglady112]

Well my goal is to beat the numbers my talon put down. I made 350hp and 328tq uncorrected. I think with dsmlink alone you can do it.

I had 680cc's, HKS VPC/GCC, PTE 60-1, 7" tall intercooler with long pipes and a horrible tune(thanks VPC). At below 10:1 A/f I made this power. Corrected was 447hp 418tq.

We will get it very close. MAC only charges $67 for 45 minutes now. So can get it dialed in really well and sqeek all that we can out.

Steven

[mac214]

What boost were you running? Was that 350 done on pump gas?

[biglady112]

28psi falling to 25psi. 110 leaded octane.

Steven

[mac214]

Hmmm, I am really curious what I will be able to do with pump gas. I guess time will tell.

[mac214]

I am going to be working on the talon again tomorrow night and probably again on Wednesday night. If anyone wants to come by and hang out, feel free to PM me and I will give you directions.

Mike