a/f gauge and boost controller probs

[phastalon]

i finally got my gauges in. the boost gauge is runnig good but my air/ fuel isnt working i think my 02 sensors dead. i hooked it up just like it said on jumptronix site, are there any other ways to try? also i hooked up my boost controller and have it set at stock level for now but i tried turning it up for a run and it wont go past 13 psi. (prolly a good thing) anyways any ideas would be appreciated.

chad

[hoffman]

its probably the stock 2g bov, that will only hold 13psi, thats holding it back. or there could be a leask soe where in the i/c piping.

nope the jumptronics plugs off the top plug, engine side, middle wire, white one. then i use the power and ground off the ecu also.

when we log it today, we'll find out for sure.

[DlandryTSI]

If you want a 1g bov I have one sitting on my bench. $50

--Dave

[XakEp]

If youve got a 2G i have a 3000GT BOV that will pop right on your upper IC pipe with no mods... 50$ and its yours..

[phastalon]

doesnt the 300gt bov leak to? also where are you guys located could i pick it up saturday? let me know

chad

[DlandryTSI]

I'm in aurora.

--Dave

[-EpicEVO-]

The only other thing you might not want to do is keep turning up the boost. If you do that you could be another victum of a stock t-25. Make your you don't over boost that turbo, untill you have another one laying around, close by.

just a little first hand advice..