EVO III O2 Housing to Buschur 2.5" Downpipe ... ?

[Red91GSX]

EVO III O2 Housing to Buschur 2.5" Downpipe ... ?

Will I have to do any modifications to the downpipe in order to bolt it to the EVO III O2 housing? Buschur's Downpipe comes with slotted holes, therefor I would think It should be OK.

Anyone have this setup and can tell me for sure?

Thanks! :D

[Van]

I just happen to have this exact set-up. It is a perfect match! ;)

One thing though, the evo O2 hsg has a slightly steeper exit angle to it. This pushes the dp towards the transfer case and the rear driveshaft a little more than normal.
My BR 2.5" dp has a flex section in it so I just "hard-wired" it over to the stock dp hangar bracket there and that has been good for almost two years and daily driven.
When you install them you'll see right where you need a little help from the bailing wire. :D

[Red91GSX]

Originally posted by Van
I just happen to have this exact set-up. It is a perfect match! ;)

One thing though, the evo O2 hsg has a slightly steeper exit angle to it. This pushes the dp towards the transfer case and the rear driveshaft a little more than normal.
My BR 2.5" dp has a flex section in it so I just "hard-wired" it over to the stock dp hangar bracket there and that has been good for almost two years and daily driven.
When you install them you'll see right where you need a little help from the bailing wire. :D

Sweet. Thanks for the info. I will get it to work somehow. Did you install the housing with the Turbo on the car? I am not sure if the bolt on the (looking from the front) rear side will be too hard to get to or not, guess I will just have to find out the hard way! :p

Again, appreciate the help!