+ Post New Thread
Page 1 of 10
1 2 3 ... LastLast
Threads 1 to 20 of 200

Forum: Drivetrain

  1. Moved: Transmission wars

    Posted By ba109296
    • Replies: -
    • Views: -
    08-15-2006 05:17 AM Go to last post
  2. K, Clutches........ give it to me!

    K, things are finally starting to come together, just a couple more things to take care of, then I will start to fix (get a new one, and balance...

    Posted By hisandherturbo
    6 Pages
    1 2 3 ... 6
    • Replies: 50
    • Views: 15,774
    07-05-2007 02:44 PM Go to last post
  3. What transmission oil is everyone using?

    Just curious what kind of manual transmission oil everyone is running in their cars? Looks like Jack suggests Mobil 1 in his transmissions. I've...

    Posted By rodent
    5 Pages
    1 2 3 ... 5
    1 Deleted Post(s)
    • Replies: 42
    • Views: 15,698
    01-14-2008 10:56 AM Go to last post
  4. Need a traanny nose piece.

    Well my car is in the shop and apparently the nose peice on the tranny is not replacable, you have to replace the whole front peiece of the...

    Posted By toutsuu
    4 Pages
    1 2 3 ... 4
    • Replies: 34
    • Views: 14,221
    03-28-2006 02:26 AM Go to last post
  5. Car stuck in RWD? Weird

    Don is gonna help me out on this, but I thought I would post it to pick your brains. My car, with its brand new clutch and flywheel (well, 1200 miles...

    Posted By birelshifterkart
    4 Pages
    1 2 3 ... 4
    • Replies: 31
    • Views: 11,508
    01-23-2007 02:58 PM Go to last post
  6. I need some opinions

    Ok, here's the story: My friend and I are attempting to go through a whole engine and drivetrain rebuild in his 92 tsi. We have the block and head at...

    Posted By eclipse92gsx
    4 Pages
    1 2 3 ... 4
    • Replies: 31
    • Views: 12,680
    04-13-2006 12:31 PM Go to last post
  7. 2g Transmission and Transfer Case Differences

    I read that there's a difference between 95-96 and 97-99 transfer cases. The splines are the same (23 spline) but the gearing is different. This...

    Posted By rodent
    3 Pages
    1 2 3
    • Replies: 29
    • Views: 31,237
    08-11-2008 12:53 PM Go to last post
  8. Group buy T-case upgrade

    So far there are five at the Driveshaft Shop and looking for ten. I am sending atleast two others so that makes seven. He said he might do it if he...

    Posted By robert
    3 Pages
    1 2 3
    • Replies: 26
    • Views: 9,942
    01-29-2007 11:54 AM Go to last post
  9. Exclamation HELP!!! Weird Clutch Disengagement Issues

    So on my way home from Denver today, I take my exit and wait at the light. When I try to go when it turns green it's hard to get into gear. It gets...

    Posted By Reef187
    3 Pages
    1 2 3
    • Replies: 25
    • Views: 11,393
    03-20-2008 08:48 PM Go to last post
  10. filling AWD MT Gear oil

    Sort of a stupid question, but I need to make sure I'm not wrong here. When filling the transmission, I want the vehicle to be flat, it takes about...

    Posted By liteyouup
    3 Pages
    1 2 3
    • Replies: 23
    • Views: 8,480
    08-23-2006 09:29 AM Go to last post
  11. need some clutch ideas?

    Ok, I have to replace the clutch!! I have an 18g-8cm^2 TDO6H, FMIC, DSMLink, alky inj, yadadada,etc.. anyways I regularly push 24psi, this is...

    Posted By exiletalon
    3 Pages
    1 2 3
    • Replies: 22
    • Views: 10,031
    10-13-2006 08:27 AM Go to last post
  12. Clutch ???

    Ok i been biulding on my 1gen for some time now i ate up my stock clutch and have dyno @ 305whp i could have gone more but my clutch would slip and...

    Posted By Cyclone
    3 Pages
    1 2 3
    • Replies: 22
    • Views: 10,304
    02-14-2008 09:41 AM Go to last post
  13. If your half-shafts break, or if you break a hard to find REAR halfshaft

    I was having non-stop problems trying to track down a Driver's Rear half-shaft. I put a WTB ad out on CL, hit up people I knew, asked on here, no...

    Posted By BLueBeast
    3 Pages
    1 2 3
    2 Deleted Post(s)
    • Replies: 22
    • Views: 16,824
    04-16-2010 01:47 PM Go to last post
  14. ... and survey says

    A stripped 1st gear, shattered bell housing side main shaft bearing. I suspect the bearing failed, letting the shaft move which resulted in 1st...

    Posted By Hal
    3 Pages
    1 2 3
    • Replies: 22
    • Views: 16,121
    09-19-2010 09:20 PM Go to last post
  15. Sheptrans Vs. Team Rip

    I've finally gotten the parts i need for my car, it turns out it wasnt 5th that went out it was the transfer case, which in turn broke the viscous...

    Posted By denverdandb
    3 Pages
    1 2 3
    • Replies: 20
    • Views: 10,685
    08-14-2006 05:28 PM Go to last post
  16. Aftermath from Last Weds.

    Went to Bandi last Weds and managed only to get one partial run in. Did a launch on antilag with about 20psi on tap. Spun all through 1st and...

    Posted By Mirage
    2 Pages
    1 2
    • Replies: 19
    • Views: 8,559
    07-27-2006 12:45 PM Go to last post
  17. Sbr lsd insert

    I installed a sbr lsd lastnight went out and drove it this morning and the thing wants to pull to the left really bad. I no the wheels are straight...

    Posted By jaysmirage
    2 Pages
    1 2
    • Replies: 19
    • Views: 8,070
    02-08-2008 10:34 PM Go to last post
  18. Fly wheel bolts

    I have a 7 bolt engine and I just got a new aluminum fly wheel and I have been told that I need to get new bolts that are shorter in order for it to...

    Posted By TwinRIce
    2 Pages
    1 2
    • Replies: 18
    • Views: 8,779
    01-16-2008 12:09 PM Go to last post
  19. Tranny question!

    I am looking at a talon tsi with 160,000. He says it runs strong but needs a tranny. If i get it, i would be doing a sheptrans stage 1 or 2 rebuild....

    Posted By boosthard91
    2 Pages
    1 2
    1 Deleted Post(s)
    • Replies: 16
    • Views: 7,113
    12-31-2006 01:04 PM Go to last post
  20. My excuse for 2.0 60'

    Here is pictures of my excuse for 2.0 60' with 117mph trap Biiiiggg pictures. http://www.awdboost.com/seth/gsx/images/clutch1.jpg...

    Posted By sbiggi
    2 Pages
    1 2
    • Replies: 16
    • Views: 7,094
    09-02-2006 07:39 AM Go to last post

+ Post New Thread

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts